non-toxic polyresin tree root ornament is perfect for adding a little character to your aquarium.
1.Firstly wash the resin ornament with clean water, take out all accessories and put them aside.
2.Place the white sand into the sand slot
3.Cut the tube into 2 pieces(#A & #B), connect the straight joint (#6)to the Air- tube (#A) and Air-outlet(#4)
4.Finally, connect the T control join (#7)to the one of the air-tube(B) and the other side to the air pump, and plug in power to use.( air pump is not included)
5.The T control joint can adjust the air output.
Color: As picture shown
Dimension: 7.5 x 7.1inches(H*W)
1 x Resin ornament
1 x White sand
1 x Sand slot
1 x Air-outlet
1 x Air tube
1 x Straight joint
1 x T control joint
- Comes with 1 bag of sand and airline tubing to creat quick sand decor scene.(requires air pump,Not Included, usually use a 8W power air pump.If the water level is above 50cm,requires air pump with 10-15W power)
- Must connect with air pump to create the running sand effect
- Sandblasted finish prevents water contamination, safe and non-toxic
- Resin material, long lasting in underwater or arid environments
- Measures about 7.5Inch Height 7.1Inch Width.(Note: Pls check the fourth and fifth picture for installation instruction, thanks)